Antibacterial Wipes
Active Ingredient(s)
Benzalkonium chloride 0.13%
Purpose
Antiseptic
Use
Antiseptic. For handwashing to decrease bacteria on the skin Apply topically to the skin to help prevent cross-contamination Recommended for repeated use. Dries in seconds Not to be used on therapeutic devices and hospital.
Warnings
For extemal use only Do not use in or contact the eyes Discontinue useif irritation and redness develop. if condition persists for more than 72 hours consult a physician. keep out of reach of children unless under adult supervision. lf swallowed. get medical help or contact a Poison Control Center immediately.
Do not use
Do not use in or contact the eyes Discontinue useif irritation and redness develop. if condition persists for more than 72 hours consult a physician.
OTC - WHEN USING SECTION
Pull through about one inch. Replace cover Pull out wipes as needed and snap off at a 90° angle. Keep cap closed to prevent evaporation Wipe hands, fingers, interdigital areas and wrists thoroughly with towelette. Be sure to utilize the entire wipe surface, Allow to dry lf hands are visibly soiled or contaminated use first wipe to clean hands then discard wipe Sanitize with a second wipe discard after single use.
OTC - STOP USE SECTION
/
OTC - KEEP OUT OF REACH OF CHILDREN SECTION
keep out of reach of children unless under adult supervision. lf swallowed. get medical help or contact a Poison Control Center immediately.
Directions
To start feed: Remove cover and discard seal from container. From center of toweled roll, pull up wipe corner, tear off first wipe for use. Twist next wipe into a point and thread through the hole in the container cover.
Other information
Lot No. and Expiration Date can be found on canister.
Inactive ingredients
Bronco Ethylhexylglycerin Didecyldimonium Chloride Propylene Glycol Glycerin water