Electrum Numb Foam
Uses
can be used instead of soap and water to help clean minor cuts, scrapes, and burns.
Directions
- For the temporary relief of discomfort and pain associated with dermal procedures such as tattoo removal, tattoo, dermarolling, electrolysis, microblading and piercing.
- Temporarily relieves pain and itch while helping prevent infection
RECENT MAJOR CHANGES SECTION
Directions for Use were added.
WARNINGS SECTION
For external use only
- avoid contact with eyes
- do not exceed recommended dosage unless directed by a doctor
OTC - DO NOT USE SECTION
Do not use
- in the eyes or apply to large areas of body
- longer than 1 week unless directed by a doctor
- in large quantities particularly over raw surfaces or blistered areas
- ask a doctor before use if you have deep or puncture wounds, animal bites, or serious burns
OTC - STOP USE SECTION
Stop Use and ask a doctor if
- condition worsens or symptoms persist for more than 7 days or clear up and occur again within a few days.
INACTIVE INGREDIENT SECTION
Inactive Ingredients: Allantoin, Aloe Barbadensis (Aloe) Powder, Arnica Montana (Arnica) Extract, Caprylyl Glycol, Cocoamidopropyl Betaine, Deionized Water, Disdoium Cocoamphodiacetate, Glycerin, Hexylene Glycol, Phenoxyethanol, Sodium Chloride.
OTC - KEEP OUT OF REACH OF CHILDREN SECTION
Keep out of reach of children:
If swallowed, get medical help or contact a Poison Control Center right away.
OTC - QUESTIONS SECTION
Questions? 574-975-3632
OTC - ACTIVE INGREDIENT SECTION
Active Ingredient
Lidocaine HCL 4%
OTC - PURPOSE SECTION
Purpose
Topical anesthetic
First aid antiseptic
STATEMENT OF IDENTITY SECTION
ELECTRUM NUMB FOAM FOAMING ANESTHETIC
DOSAGE & ADMINISTRATION SECTION
Directions
Shake well before each use. Apply 2 to 3 pumps of foam soap and gently rub into skin. Leave it on for 5 to 10 minutes.
Rinse off gently with running water or wipe with a clean paper towel. Use before, during and after the procedure.